Hanging stickers

There are different types of stickers which is why we are giving you two different methods to stick them to the wall

NOTICE 1 FOR MULTICOLOURED STICKERS
Application


The surface on which you are applying the sticker, for example a door, wall, or piece of furniture, must be clean, dry and relatively smooth. Blot with an appropriate product if necessary. A smooth duplex or vinyl wallpaper surface would be ideal.


Remove the protective paper backing.
Carefully apply the sticker on the designated area using a dry cloth.
Remove the protective transparent film if it has one.
The position of the sticker can not be changed once it has been applied.

Special instructions
It is possible that the sticker will not adhere fully to a highly textured vinyl wallpaper with a sheen. If this is the case blot the surface, on which the sticker is to be applied, with a cloth dampened with methlated spirits, allow to dry and then apply the sticker. Methlated spirits does not damage vinyl wallpaper.

If you have just painted your walls, you should wait between 15 and 20 days before applying the stickers. If you do not, the stickers may peel away from the walls.

The sticker must not be cleaned with a solvant.
Not suitable for children under the age of 3 years old.


NOTICE 2 FOR UNICOLOURED STICKERS
Leave the sticker for 24h at room temperature to allow the vinyl to flatten fully.

Please note the application of each sticker is very delicate. It is important to first read and then follow to the instructions carefully.

The surface on which you are applying the sticker, for example a door, wall, or furniture item, must be clean, dry and relatively smooth. Blot with an approproate product if necessary. A duplex or vinyl wallpaper surface with little textural relief would be ideal.

Hanging time : 20-30 minutes
Equipment required : a pair of scissors and a clean cloth

Preparation
Take the time to look at the components of the sticker you have in front of you :

a) the protective transparent film (where applicable)
b) the sticker
c) protective paper backing

If the sticker has a protective film before applying the sticker place it on a table (protective backing side down (c)) and rub the transparent film with a cloth so that the film adheres in full to the sticker.

Application
1 -First lay the sticker flat on a table with the film facedown (a). Peel back 20cm of the paper backing from the right hand side while holding down the film (a) and sticker (b) with the other hand.

2 - Cut away the 20 cm of backing paper that you have peeled away from the film and the sticker.

3 - Apply the right hand side of the sticker in the position required without removing the transparent film. At this stage only the right hand side of the sticker should be applied to the surface.

4 – With a cloth rub the applied section to remove any bubbles and ensure the sticker has adhered well to the surface.

5 – Lift the left hand side and carefully remove the backingpaper while rubbing the sticker with a cloth as the paper comes away.

6 – Rub the entire surface with the cloth to ensure the removal of all bubbles from under the film.

7 – Carefully remove the transparent film from the top to the bottom leaving the sticker applied to the suface.


The position of the sticker can not be changed once it has been applied.

Special instructions
It is possible that the sticker will not adhere fully to a highly textured vinyl wallpaper with a sheen. If this is the case blot the surface, on which the sticker is to be applied, with a cloth dampened with methlated spirits, allow to dry and then apply the sticker. Methlated spirits does not damage vinyl wallpaper.

If you have just painted your walls, you should wait between 15 and 20 days before applying the stickers. If you do not, the stickers may peel away from the walls.

The sticker must not be cleaned with a solvant.
Not suitable for children under the age of 3 years old.

<anterior>